Basler A501k Manual do Utilizador descarregar pdf (Página 106)

Configuring the Camera

4-8 Basler A500k

PRELIMINARY

4.2.2.4 Write Command

In the normal case, when a write command is sent to the camera, the camera responds with an

ACK.

If the camera receives a write command with an unknown command ID in the descriptor, it will

respond with an ACK but will not perform the write.

After a write command has been issued by the host, the host can verify the write by issuing a

corresponding read command and checking that the returned data is as expected. The host can

also issue a camera status read command (see section 4.2.8) and check the returned data to see

if an error condition has been detected.

For many of the write commands listed in the Tables on pages 5-4-11 through 5-4-

31, only data within a specified range or a specified group of values is valid. The

camera does not perform a check to see if the data in the write command is within

the allowed range or specified group of allowed values.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 149 150

Sem comentários

Basler A501k Manual do Utilizador Página 106